Hello,
I'm 99% confident I can use this part for a single phase BLDC motor but I just wanted to ask the question so I don't make an expensive mistake.
Can I do this?
My approach would be to use the INHA and INHB inputs (3x PWM input version) to drive two of the half bridges which I would combine into an H-bridge configuration.
For INHC and INLC, I would just tie them to ground so that GHC/GLC are kept low and SHC would be high-z.
Is it ok to leave GHC/GLC floating in this configuration?
Are there other considerations that I need to account for such as inadvertently triggering one of the protective circuits?