This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.


Part Number: DRV8912-Q1

1.while the DRV8912QPWPRQ is operated normally, set the output 12 chs as high voltage ,  and the OCP status bit is not set. 

2.  short OUT3 pin to GND, the OCP bit is set.

3. we can't clear the OCP bit  by CLR_FLT of CONFIG_CTRL register  , and Ouput3 is turn off ,however, I can't set it as high again.

4. while OUT3 OCP happened ,HB3_HS_OCP is 1,HB3_LS_OCP is 0,nfault is low