This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DRV10983-Q1: debugging issue

Part Number: DRV10983-Q1

Hi Team,

1) Can the DRV10983Q1 set the PWM operating range? Now only the lowest duty cycle setting is seen, below 5% is output at 5% and below 1.5% is output at 0. Is there a maximum duty cycle setting that allows it to output at maximum speed above 98% duty cycle?

2) Can the PWM set the correspond actual speed? For example, 30% duty ratio should be 1000 rpm.

3) What is the general time for the motor to start up? Set the 1st and 2nd order acceleration to a maximum of 8 seconds to reach the target speed.

Could you help check this case? Thanks.

Best Regards,

Cherry