DRV10983EVM: Using the GUI Software

Mohamed Badawy

Part Number: DRV10983EVM
Other Parts Discussed in Thread: USB2ANY

Hello Team,

It is the first time I use the DRV10983EVM. I downloaded the software, and the required Labview software as well. However, Labview requires a license, how can I get this license?

Thanks,

Mohamed

over 1 year ago

0 Mohamed Badawy over 1 year ago

Prodigy 90 points

I found a previous post with a link to labview 2014 that works, no request for license. However I have another problem:

The Any2USB firmware needs update. I followed the steps: disconnect USB, press S1, Connect USB while pressing S1, but nothing happens

0 Mohamed Badawy over 1 year ago in reply to Mohamed Badawy

Prodigy 90 points

I managed to upgrade the USB2Any on an oder labtop with Windows 7. When I try to use it back on the original labtop, Iget the following error:

0 Mohamed Badawy over 1 year ago in reply to Mohamed Badawy

Prodigy 90 points

I am using a Power Supply to provide VCC. I set mode to voltage control and set voltage to 24V. once I connect to evm, mode changes automatically to current control, voltage drops to 1.9V and current increases to 1.86A, is this a normal behavior?

0 Venkatadri Shantaram84961 over 1 year ago in reply to Mohamed Badawy

TI__Mastermind 20992 points

Hi Mohamed Badawy,

HW may have issue, Can you send image how are you connecting VCC, GND to the board from power supply?

Thanks and Best Regards,

Venkatadri S

+1 Mohamed Badawy over 1 year ago in reply to Venkatadri Shantaram84961

Prodigy 90 points

Hi Venkatadri,

Actually 1.86A was the max current I set in the PS, I reduced this to 1.5A for safety. Using an Avometer, I measured the resistance between VCC and Gnd and it shows a short circuit.

Please let me know if the picture is not clear

0 Venkatadri Shantaram84961 over 1 year ago in reply to Mohamed Badawy

TI__Mastermind 20992 points

Hi Mohamed Badawy,

Thanks for providing the image. I don't see any issue with (I was guessing if we are making wrong polarity connection)

Looks like device may have gone bad.

Thanks and Best Regards,

Venkatadri S

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Motor drivers

Motor drivers forum

DRV10983EVM: Using the GUI Software