DRV2625EVM-CT: Help with Haptic Driver Software Settings

Claire Glattly

Part Number: DRV2625EVM-CT
Other Parts Discussed in Thread: DRV2625

Tool/software:

Hello,

I am using the haptics driver (DRV2625) with the evaluation board (DRM2625EVM-CT) to get preliminary haptic vibration data. The problem that I am having it after the system is connected and I have successfully drove the haptics motor, I am not able to put sequences in a series or add any delay between the sequences. See the highlighted section in the photo attached. Any ideas how I can fix this problem?

Example of my goal: strong click -> delay 6ms -> transition hum 1 -> delay 3ms -> soft fuzz

Thanks all!!

2 months ago

0 Hailong Chen 2 months ago

TI__Intellectual 1610 points

Claire,

Thanks for reaching out. Your question has been received. I will get you back as soon as possible, usually within 24 hours.

Best,

Hailong

0 Hailong Chen 2 months ago

TI__Intellectual 1610 points

Hi Claire,

I looked at your question. Did you try click on the ON/OFF in your red rectangle? You should be able to add a sequence by click 'on' first. Let me know if it doesn't work.

Also, the delay duration can be set at a minimal of 10ms in the GUI, not 6ms or 3ms.

Thanks
Hailong