Tool/software:
Hello!
I'm trying to use an external PWM signal to drive the DRV2511Q1 without the on-board MSP430.
I configured the jumpers on the board according to the documentation in slou448.pdf.
I biased the (-PWM) input according to DRV2511Q1 datasheet:
Now, what about these signals?
The documentation doesn't say anything about having to configure these or anything, but maybe the ENABLE line needs to be pulled up to 3v3?
FYI, this board works just fine when I use the USB based Haptics Control PC utility and the on-board MSP430.
What am I missing?