DRV8876-Q1: Output transient protections

Jessica Riley

Part Number: DRV8876-Q1

Tool/software:

Are there any recommendations for protections on the outputs of the DRV8876-Q1 device? TVS to clamp voltage transients? Diode to clamp negative voltage swings?

I am using the driver in independent PWM output control mode with a low current load (<10mA), but I want to make sure the outputs are protected from any potential transient events.

9 months ago

0 Ibinu Alaudeen Nadeera 9 months ago

TI__Genius 12991 points

HI Jessica,

Thanks for your question.

Just to confirm will you be using the independent half-bridge mode or the H bridge mode.

Thanks,

Ibinu

+1 Joshua Horlander Cruz 9 months ago in reply to Ibinu Alaudeen Nadeera

TI__Mastermind 26510 points

Hi Jessica,

A TVS diode on the OUT node would help to mitigate negative transient voltage spikes which exceed the abs max voltage. RC snubbers can also be added to help reduce ringing at the output. Most importantly though is the board layout, such as keeping the OUT current path as short as possible.

We have an app note on design considerations for high power motor driver applications, which is linked below. Some of the recommendations in the app note are more applicable to external FET drivers but a good amount of the information will still apply to internal FET drivers like the DRV8876-Q1: https://www.ti.com/lit/an/slvaf66/slvaf66.pdf

Regards,

Joshua

Motor drivers

Motor drivers forum

DRV8876-Q1: Output transient protections