This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DRV8874: Question about Ph/IN2 and PWM mode in DRV8874

Part Number: DRV8874

HI, I am going to use DRV8874 for control DC motor.

DRV8874 has 2 inputs. EN/IN1, and PH/IN2.

I want to use PH/EN control mode.

And in table 3, IF I use PH/EN mode, then I should make EN high or Low to control motor.

But In the datasheet's typical application.
EN/IN1 is connected to the PWM pin of controller.

Then should I make 100% duty of PWM to make EN high?

Can't I EN/IN1 pin to connect GPIO pin to make High or Low?

I don't want to use PWM mode. I want to use Only PH/EN mode.

Thanks.