DRV8874-Q1EVM: MSP430FR2100 MCU programming

Werner Fortgens

Part Number: DRV8874-Q1EVM
Other Parts Discussed in Thread: MSP430FR2100, MSP430FR5969, MSP-EXP430FR2311

Hi,

I have an DRV8874-Q1EVM and it works great out of the box. There is a MCU on the same board and a programming port on one side of the board. I have tried to flash the MCU MSP430FR2100, with an USB eZ430-F2013 Development Tool (that i have been redirected to via the PDF/datasheet), but seems not be compatible. Could you please explain me how to flash the MSP430FR2100 on the DRV8874-Q1EVM.

BR, Werner

over 4 years ago

0 Ryan Kehr over 4 years ago

TI__Guru 55605 points

Werner,

Happy to hear that the EVM is working well for you!

Let me investigate this and I will reply back within 1 business day.

0 Pablo Armet over 4 years ago in reply to Ryan Kehr

TI__Mastermind 37683 points

Hi Werner,

If you read section 2 of the EVM user's guide, it mentions that the MCU on the EVM is programmed using the on-board eZ-FET emulator on the MSP430FR5969 LaunchPad. The link provided in the user's guide is not correct. I apologize for that.

Here are step-by-step instructions on how to flash the MCU on the EVM:

Connect the MSP430FR5969 lauchpad to your computer via USB.
Connect the DRV8874-Q1EVM to the MSP430FR5969 via the J21 connector on the launchpad and J6 connector on the EVM. You'll need to solder a connector (850-10-050-20- 001000) to J21. Solder the connector between pins labeled "V+" and "GND" as shown in the picture below:
Flash the firmware to the MCU. Make sure to select the MSP430FR2100 as the target device. If R11 is populated on the EVM, there is no need to supply power to the EVM when flashing the firmware. The "V+" pin of the J21 connector provides the power to the MCU on the EVM.

I hope this helps you understand how to flash the EVM.

0 Werner Fortgens over 4 years ago in reply to Pablo Armet

Prodigy 30 points

Thank you very much. Is it also possible to use MSP-EXP430FR2311 at J101 pins 1,3,11,13 ?

0 Werner Fortgens over 4 years ago in reply to Werner Fortgens

Prodigy 30 points

Then i use some wires and solder them between the EVM and J101 on the MSP-EXP430FR2311

0 Pablo Armet over 4 years ago in reply to Werner Fortgens

TI__Mastermind 37683 points

Werner,

You can use the MSP-EXP430FR2311 but connect it to pin 1,3,9,13. The MSP430FR2100 has a maximum recommended VCC voltage of 3.6V. So use the 3.3V pin on J101 instead of the 5V pin.

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Motor drivers

Motor drivers forum

DRV8874-Q1EVM: MSP430FR2100 MCU programming