Part Number: DRV8432
I'm sorry for delay in answering. Here are the latest screenshots.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: DRV8432
I'm sorry for delay in answering. Here are the latest screenshots.
Hi Dimitri,
Thank you for providing the information.
Since the original thread has been locked, let's continue the discussion in this post. Please allow me a day to go over the information you sent and answer your question.
Hi Dimitri,
One concern I see with your schematic is that you seem to have paralleled the outputs. Your current configuration (M1=M2=M3=0) is for dual bridge with CBC current limit. This could explain why not all outputs were being disabled after the OCP fault. Figure 15 on the datasheet show an example of a parallel bridge configuration. Your current schematic does not match with the example on Figure 15 so you will not be able to set the driver in parallel bridge mode.
Here are my two suggestions: