TPS65263-1Q1: Loop Compensation

Gilad Dcir

Prodigy 20 points

Part Number: TPS65263-1Q1

Hello,

Do you have any theoretical material for Loop Compensation (but section 8.2.2.4 of the datasheet )?

Is it necessary for output voltages? If not, what should be dome with those 3 pins?

Thanks!

over 3 years ago

0 Ruby Li over 3 years ago

TI__Expert 7430 points

Hi Dcir

Yes, it is important to make the output stable. When choosing the values, you can refer to the user guide of this part, or you can calculate the value accoring to the datasheet and then check the values using pspice model. Regarding to the compensation type, you can refer to the application note below: compensators for type 2 and type 3.pdf

Ruby

0 Young Zhao over 3 years ago

TI__Genius 9300 points

Hi ,

Sorry that I will close this post first as there is no further concern . You can re-open it if you have any other question .

thanks for understanding .

BRs,

Young

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Power management

Power management forum

TPS65263-1Q1: Loop Compensation