Other Parts Discussed in Thread: TPS3808
Hello
Is it available to use a pull-up resistor for the reset pin in 1K or less like the circuit diagram I attached?
Best regards.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello
Is it available to use a pull-up resistor for the reset pin in 1K or less like the circuit diagram I attached?
Best regards.
Hi Louis,
Yes, there is no issue to use 1K as a pullup resistor on the TPS3808. See below for the limits on IRESET for the TPS3808:
If there are no other questions, please click on "resolved" to close the thread. Good luck to you!
Ben