Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 65 subscribers
  • Views 180 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

TL431: voltage between anode and cathode

UCC28086: ISET(RSET) calculation

einfochips an Arrow Company
Intellectual 380 points
Part Number: UCC28086

Dear Sir,

This is Vaibhav Kundariya from eInfochips an Arrow company.

we are working on UCC28086 based Push-pull SMPS. So can you please help us to calculate the RSET value for ISET pin of the UCC28086D controller?

As per the above image calculation 

VOSC peak =1.5V

RF = 1K

RAMP Voltage Height = ?

Can you please guide us on how to calculate RAMP VOLTAGE HEIGHT in the above equation for the UCC28086D controller? 

Thanks in advance

-

Vaibhav Kundariya

  • 0
    TI__Guru 57825 points

    Hi

    ISET peak is listed in table on page 4, typical 30uA.

    Based on page 6, IRAMP = 5 x ISET = 150 uA, also see page 4

    RAMP Voltage Height is your design need for your current slope. I think you can start with 0.5 x Vcs = 0.5 x 0.52V = 0.26V, 0.52V is maximum Vcs based on page 4. Then you can get your initial RSET for your current slope compensation. RSET will need to tune up on bench work.