ISO5451: RST reset pull up resistor value

Dylan You

Part Number: ISO5451

Dear Teams,

My customer is asking what is the resistor value on the internal RST pin? The reason they are asking is because they have a reset signal with maximum output current capability 50mA. They are wondering whether it can successfully apply a low pulse to reset the fault latch?

Thanks!

Dylan

over 2 years ago

0 Don Dapkus over 2 years ago

TI__Guru**** 189399 points

Hi, Dylan,

The resistor draws 100 uA as seen in the datasheet:

50 mA is more than enough current.

Please press the Green button if this answered your question. Otherwise, let us know what else you need.

Best regards,

Don

0 Dylan You over 2 years ago in reply to Don Dapkus

TI__Intellectual 2630 points

Hi Don,

Could I think that it might not working properly if the reset signal has more than 100uA current?

Thanks!

Dylan

0 Dylan You over 2 years ago in reply to Don Dapkus

TI__Intellectual 2630 points

Hi Don,

Based on datasheet, the IIL low-level input leakage current is -100uA. The VCC=5V if assumed, and the RST pin is 0V. Then the typical value of pull-up resistor should be (5-0)V/100uA=50Kohm. Am I right?

Thanks!

Dylan

0 Don Dapkus over 2 years ago in reply to Dylan You

TI__Guru**** 189399 points

Hi, Dylan,

Yes, that is correct.

Best regards,

Don

Power management

Power management forum

ISO5451: RST reset pull up resistor value