• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 62 subscribers
  • Views 113 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS25940-Q1: [TPS25940-Q1] Inquiry about PGTH connection resistance value

MJ Jeon
Genius 5240 points
Part Number: TPS25940-Q1

Hi, TI Support Team

Regarding the PGTH pin of the TPS25940-Q1, if it is not used as shown below, it should be connected to the OUT pin or GND.

In the VCU, it is connected to the OUT pin using a 100K resistor. (R5=DNI, R4=100K in the circuit diagram below)

Please inquire if there is a standard value when connecting to the OUT pin.

Thanks.

Regards,

MJ