Hello TI-Team,
Can I use the SS/TR-Pin to control the load current?
Measure the load current by adding an ext. Opamp as current-controller and feed back the signal to SS/TR-Pin to reduce the duty-cycle.
Best regards,
Frank
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello TI-Team,
Can I use the SS/TR-Pin to control the load current?
Measure the load current by adding an ext. Opamp as current-controller and feed back the signal to SS/TR-Pin to reduce the duty-cycle.
Best regards,
Frank
Hi Frank,
The SS/TR pin is used only for controlling the startup ramp of the device. As soon as the SS/TR pin voltage exceeds the reference voltage of 0.6V, the device completes the startup phase and uses an internal 0.6V reference for steady state operation. It won't be possible to control the output voltage in steady state via this pin.
Best regards,
Varun
Hi Frank,
Do you have any further questions? I am closing this thread. You can reopen it by commenting here.
Best regards,
Varun