Dear Sir/Ms.
I look at that there is no status register in the register table in the datasheet, and I/O did not find a similar one? I need your help. How can I know that the battery is fully charged?
Best Regards,
Kami Huang
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Dear Sir/Ms.
I look at that there is no status register in the register table in the datasheet, and I/O did not find a similar one? I need your help. How can I know that the battery is fully charged?
Best Regards,
Kami Huang
Hi,
You can refer to this FAQ post: https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1019605/faq-do-the-following-chargers-have-a-termination-current-setting-bq24715-bq24725a-bq24735-bq24770-bq24773-bq24780s?tisearch=e2e-quicksearch&keymatch=BQ24773%20termination
This charger IC is intended to be used with a battery gauge which would detect end of charge, and which would then handle termination.