• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 62 subscribers
  • Views 339 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ATL432LI: ATL431LI Ika

Rock Shao
Expert 2895 points
Part Number: ATL432LI
Other Parts Discussed in Thread: TL432, TL432LI, , ATL431LI

Hi,
Because the TL432 and TL432LI are out of stock, and ATL432LI we has stock,
so I want to use ATL432LI to replace the LA431OCRPA, and the datasheet as the following link, but the customer consider that the Ika is too low (15mA max), 
http://www.liteon-semi.com/upfiles/tecfile01445239981.pdf 

And you can see the schematic with the calculate was 19mA ((Vo-0.7)/R306=(30-0.7)/1.5K=19.53 mA). Is that ok for used the ATL432LI? 
Or are there other calculation methods that can convince the customer? thanks.

Best regards
Rock

  • +1
    TI__Mastermind 39105 points

    Hi Rock,

    The calculation is almost correct but needs modification.  The ATL432LI needs equal or greater than 2.5V at the cathode for proper operation.  Therefore, the actual calculation should be:

    (30V - 2.5V) / 1.5Kohms = 18.33mA.

    Even with the new calculated cathode current of 18.33mA, it is still too high for the ATL431LI.  My suggestion is to have the customer increase the resistance so the IKA is around 15mA.

    Ben