This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCC5350-Q1: Clamp pin connetion when using bipolar power

Part Number: UCC5350-Q1

Dear. TI engineers

VCC2 is using 15V and VEE2 is -5V.

1. Should the clamp pin be connected to the FET's GATE? or do I need to connect to VEE2?

2. And what's the difference when connected to GATE or VEE2?

Best regards,

Jaehoon Kim