LM809: spec check

Hi,

I dont believe the attached file made it through.  Can you please resend the image?

If I understand your request, you are looking for a voltage threshold variant of 2.4V, correct?

We do have a newer part called TLV803E which was released last year.  There is a 2.4V OPN variant (TLV803EA24DCKR) but it has an open-drain active low output instead of a push-pull active low output.  Also, the OPN variant has 200ms reset time delay and comes in SC-70 which is very similar to the DBZ package.  The good thing is that the pinout is the same.  At this moment though, we are out of stock with this particular variant.

Please let me know if you have any other questions.  Thanks!

Ben

Hi Ben

TLV803 is open-drain, and currently there is no pull up resistor reserved on the customer's board; The board footprint is SOT-23, SC70 cannot be used; So we must look for pin 2 pin Any other suggestions?

Hi Gareth,

There is no other suggestions unless the customer is willing to change some specs like the voltage threshold.

Ben

Hi Gareth,

No problem!  Good luck to you!

Ben