TPS2662: TPS2662 Power mux?

Excuse me, just one question so if we have  26623 which clamp's behavior will be?

yes, I found these information, thank you. Unfortunately due the lack TPS26620,1,4,5 we could bought only TPS26623. Maybe  you have some idea how organize POWER MUX with this type?

Thank you in advance

No.

We have to use TPS26620 or TPS26621 or TPS26624 or TPS26625.(Overvoltage cut-off, adjustable variants)

unfortunately we could buy only 26623. How do you think is this circuit could help resolve this issue?

FLT through inverter goes to SHDN second eFuse

Hi Denys,

That will work. The only concern is SHDN/ control is very slow unlike OVP as you see below. so, you may need large buffer capacitor at the output because of this slow switch over from primary path to secondary path. 

Instead of that, you can follow the same approach and control OVP pin of secondary eFuse.

Thank you, about Buffer capacitor I thought maybe 10000uF will be enough? I don't get you point of view about secondary OVP. Do you propose connect inverter output with OVP? If not could you please explain more detail?

And one question about OVP it has internal switch of at the level 38V, I calculated my own switch of at 36 V and add some resistor( which i calculated). Will it works for this type TPS2662?

Thank you Rakesh