Hi team,
We want to verify that the INT1 signal sends an Interrupt when the power button is pressed, but the current test is that the Interrupt remains at a high level after the power button is pressed.
Could you suggest how we can check and set this feature? Thanks!
Best regards,
Sam Ting
Hi Sam,
Please read through the device datasheet section "6.5.3.7 INT1" about the INT1 signal, and check If following 2 interrupt sources have been masked?
Thanks!
Phil
Hi Phil,
Thank you for your support. Engineers checked the 0x51 Interrupt mask register and it was indeed masked.
In addition, is there a TPS659114 driver that can be provided as a reference? OS is yocto, kernel version : 4.1.15
Best regards,
Sam Ting
