Hi, i´m new graduate in Electrical Engineering and new using PSpice for Tl
I have this design suggest by Workbench tool and that match with datasheet for 12-24 V to 5V-3A
And when i simulate on PSpice i get this output, its normal to have that current peak on inductor?
Beacuse in this simulation https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1064974/lmr33630-simulation-through-pspice-model-in-ltspice-results-in-0v-at-output?tisearch=e2e-sitesearch&keymatch=LMR33630#, the current on inductor dont have this peak.
Another issue, its about the time to take to simulate 2ms, its because my computer its a only 8GB Ram, 256 SSD and I5 11G? If its is the root cause, could you guys suggest a good configuration ?