in the DS on page 24 it says
The host may change the reset behavior at any time after MR going low and prior to the MR_HW_RESET timer expiring. It may
not change it however from another behavior to a HW reset (Power Cycle/Autowake) since a HW reset can be
gated by other condition requirements, such as VIN presence (controlled by MR_RESET_VIN bit), throughout the
whole duration of the button press.
Does this mean:
- I can change the bq25150 registers while I’m in the HW reset phase(P1 pressed) at the exception of the HW reset behavior( go in ship mode after HW reset,…)?
- Can we abort the HW reset by setting the b7-6 in register ICCTRL1(0x036) to 2b01?
- Are the bq25150 registers set to default state after a HW reset?
Thanks foo your help!