TPSM53602: PSpice model no VOUT

Victor Tolosana

Part Number: TPSM53602

Hello,

I'm trying to simulate a TPSM53602 circuit with PSpice for TI.

Here is my circuit :

I'm trying to do a DC sweep from 10V to 28V. The sweep works but the output voltage is always very small (a few nV instead of 3.3V).

Simulation settings :

I tried other analysis types and parameters to no avail.

What could be the problem ?

Thank you.

Regards,

Victor Tolosana

0 Frank De Stasi over 2 years ago

Hello

I would first try to replace the input battery with a step pulse source going from 0V to 12V in 100us, or so.

And do a transient simulation and see if you get an output voltage.

Then you can use a ramped input for your input sweep.

Thanks

0 Frank De Stasi over 2 years ago in reply to Frank De Stasi

Hello

I will close this post because of inactivity

Thanks

Power management forum