Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ25700A: BQ25700A

Part Number: BQ25700A

I am currently trying to configure bq25700a into charging a battery. I have been able to successfully set ChargeOption0 to enable charging, set MaxChargeVoltage and MaxChargecurrent but I'm not able to get the ic to charge my battery. How I verified this is using a multimeter setup and the adc that measure IDCHG on the pmic. My setup is a raspberry pi connected to pmic via i2c pins and using direct I2CSET AND I2CGET commands. Can anyone suggest what else I should be doing or what I'm potentially doing wrong?