Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 64 subscribers
  • Views 210 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LM5017EVAL: Why Diode is used between Vout1 and Vcc pin?

Arvind Kumar
Prodigy 40 points
Part Number: LM5017EVAL
Other Parts Discussed in Thread: LM5017

Hello All,

I am going through this document  https://www.ti.com/lit/pdf/snva611. 

Vout1 is 10V and Vcc is regulated at 7.6V(as per datasheet) so Diode(D2) will be always in forward bias then why here you have used Diode (D2) ?