UCD90160: UCD90160 wont program via the command line tool.

Mike Gerlach

Part Number: UCD90160

Sorry, just getting back to this since we had a board spin. We updated our board with the UCD90160 for this spin.

The command line programming still does not work even though the script runner and full blown version do.

The fusion tool reports the following address

here is a copy of the UCD file someone else asked about.

0 Mike Gerlach over 2 years ago

and here is the error from the cmd line (running as administrator)

0 Mike Gerlach over 2 years ago in reply to Mike Gerlach

not sure if that image can be read... it says...

"FusionConfigWriter: no devices found matching your device criteria; verify no other SAA-based tools are running

FusionConfigWriter: existing due to error"

I did verify no other tools are running

0 yihe over 2 years ago in reply to Mike Gerlach

What's your GUI version?

Regards

Yihe

0 Mike Gerlach over 2 years ago in reply to yihe

0 Mike Gerlach over 2 years ago in reply to Mike Gerlach

found this command as well...

0 yihe over 2 years ago in reply to Mike Gerlach

Your file and Fusion version are good.

Do you close the fusion GUI when running the command line tool?

have you retried after power cycle the board?

Regards

Yihe

0 Mike Gerlach over 2 years ago in reply to yihe

The GUI is closed. I have power cycled many different ways. I have even disconnected/reconnected the USB adapter.

0 yihe over 2 years ago in reply to Mike Gerlach

That's very strange.

I tested your file with the same fusion GUI and did not see any issue.

I would suggest to uninstall the 7.6.1 version GUI and install this Fusion- GUI 7.7.8 [beta] version.

Regards

Yihe

Power management forum