This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCD3138PSFBEVM-027: Testing the PSFB Firmware in open loop

Part Number: UCD3138PSFBEVM-027
Other Parts Discussed in Thread: UCD3138


What do you think the best way would be to test the included PSFB firmware in open loop so I can just see the DPWM signals without connecting the evaluation board?

I would like to see the DPWM signals from the UCD3138 stand-alone, using the included firmware. 

Should I disconnect the filter, take it out of normal mode, turn off CLA?

Would it be faster to do it from the GUI? I basically wanted to measure the dead times, and I was having some trouble getting accurate results

I appreciate the help!