LM4040-N: + Sign on Cathode Terminal Side

Ray Vincent Aranzaso

Part Number: LM4040-N
Other Parts Discussed in Thread: LM4040

Hi,

Good Day. I would like to verify if the "+" sign on the cathode terminal side on pin configuration of LM4040-N, page 4 of the datasheet is correct.

Checking the datasheet of LM4040, it does not mention the signs of each pin. Knowing the "+" should be on the anode side.

Please advise. Thank you very much.

Best Regards,

Ray Vincent

0 Masoud Beheshti61 over 1 year ago

Hello Ray,

Please refer to this table.

Thanks.

0 Ray Vincent Aranzaso over 1 year ago in reply to Masoud Beheshti61

Hi Masoud,

Good Day. How about the positive and negative sign? Since the orientation of the sign is same on the image below. Please advise. Thank you very much.

Best Regards,

Ray Vincent

0 Masoud Beheshti61 over 1 year ago in reply to Ray Vincent Aranzaso

Hi Ray,

Anode is normally grounded. So the positive/negative sign as shown in the datasheet is correct.

Thanks.

Power management forum