This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS7A8300: TPS7A8300

Part Number: TPS7A8300

Hello Team,

I am using TPS7A8300RGRR in one of my project for 5V to 3V3 Conversion.

In that, the Power Good (PG) Pin is always in Low state (i.e 0V) even the VIN, EN & VOUT are within the range (i.e Both I/P & O/P Voltages are fine).

I have connected PG pin with Vout(3V3) using 10K Pullup resistor (as per datasheet).

Please guide me to resolve the issue (i.e to make PG pin to High).

Also Let me know What are the parameters to be verified to make PG pin to high.

Note: In my design I am not using SENSE & BIAS pins. (left open)

Thanks & Regards,

Prabakaran P