BQ76PL102: BQ76PL102 simulation

Cedrick Biellmann

Part Number: BQ76PL102

Hello,

I want to simulate the circuit in page 7 of slua524b.pdf note application concidering that the top cell (V2= 4.5V) charge the bottom cell (V1=3.6V).

Have you information concerning the PUMP2S and PUMP1N signal because it is not clear for me.

Thank you,

Biellmann Cedrick

Vitesco technologies Toulouse

0 Matt Sunna over 3 years ago

Hi Cedrick,

The best resource would be this document from the BQ76PL102 product folder: https://www.ti.com/lit/an/slua524b/slua524b.pdf

This is a very old device that is not in high use, so there may not be a product expert who can offer much support.

Best regards,

Matt

0 Cedrick Biellmann over 3 years ago

Hello,

Is this component can become obsolete because we want to test it for an application in active balancing battery?

Cedrick Biellmann

0 Matt Sunna over 3 years ago in reply to Cedrick Biellmann

Hi Cedrick,

No, it is rare for TI to make components obsolete. There just may be limited technical support to help with device usage.

Best regards,

Matt

Power management forum