I need to understand how to configure SND 9039 LDO's in order to get out programmed voltage before connected to unprogrammed processor.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
I need to understand how to configure SND 9039 LDO's in order to get out programmed voltage before connected to unprogrammed processor.
Hello,
I'm not familiar with SND9039 and I can't find much information online about it. Can you please elaborate on what exactly you need help with?
Thanks,
Nick
Here is block diagram. If I connect all configurable LDO's to processor rail, which are in default disabled. Because my power is coming out my processor doesn't boot. LDO register's are written through I2C bus. How do I solve this problem?
Hello,
I am trying to find the correct group to support this; even though there are LDOs integrated in this device, the LDO group does not support this device.
I hope to find the correct group by tomorrow 8/5/22. I'll update this post when I find the correct group.
Thanks,
Nick
Hello,
I am re-assigning this post to the responsible team.
Regards,
Nick
Hi Mahesh,
LDOs can be controlled by I2C. LDOs not enabled by default would need to be brought up over I2C.
Thanks,
Daniel W