• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 194 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

BQ27530-G1: Not Responding

BQ27530-G1: BQ27530-G1 Can't be program and we try to use EV2300 program the chip ,it will shut down when it program process.

Lawrence He
Expert 2960 points
Part Number: BQ27530-G1

Hi, Support Team

We can't be program BQ27530-G1 and try to use EV2300 program the chip ,it will shut down when it program process.

How to fixed cannot program issue.
We check REGIN and CE pins the gauge is enabled and powered.

if any, Please advise me.

Thanks,


Best regards,


Lawrence

  • 0
    TI__Guru** 104020 points

    Hello Lawrence,

    Can you explain the exact steps taken and what is being observed?

    Are you able to communicate successfully before programming and after it becomes unresponsive? If this is the case it is likely the gauge may have had an issue during programming and become bricked. If the power is temporarily lost while programming this will happen.

    Are you able to recover the gauge?

    Sincerely,

    Wyatt Keller

  • 0 in reply to Wyatt Keller
    Expert 2960 points

    Hi, Wyatt

    1.Can you explain the exact steps taken and what is being observed?

     when we program the bmu with EV2300 with Battery management studio it will break off and we try again and again it  also can't be program

    2.Are you able to communicate successfully before programming and after it becomes unresponsive?

     yes,if not communicate successfully it will has reminded I2C not connect.

    3.If this is the case it is likely the gauge may have had an issue during programming and become bricked. If the power is temporarily lost while programming this will happen.

     No ,the power is always normally

    Are you able to recover the gauge?

    the  chip need reball maybe we can't do it

    -------------------------------------------------------------------------

    should we dump log.file or or screenshot?

    if any, Please advise me.

    Thanks,

    Best regards,

    Lawrence

  • 0 in reply to Lawrence He
    TI__Guru** 104020 points

    Hello Lawrence,

    If the gauge is programmed and after programming becomes unresponsive it is most likely bricked from bad programming. The only way to recover this is if the gauge is not sent to firmware mode after programming, you can attempt to program it again, if it is sent to firmware mode with bad programming it is not recoverable unless you can get it back into ROM mode.

    Sincerely,

    Wyatt Keller