TPS65982: How to use TPS65982 to output the "cable orientation" logic to control POL in TUSB546EVM?

DanS

Part Number: TPS65982
Other Parts Discussed in Thread: TUSB546EVM

Hi,

In the TUSB546EVM, GPIO2 from TPS65982 is connect to the POL signal line. May I know how to enable the PD controller to output the logic according to the orientation of the cable plugged to the connector?

Thanks.

over 2 years ago

0 DanS over 2 years ago

Intellectual 400 points

Hi,

I am referring to GPIO2 of TPS65982 as shown in the diagram below. Thanks.

0 Raymond Lin over 2 years ago in reply to DanS

TI__Mastermind 32436 points

Hi Dan,

You should be able to use either one of these events to detect based on CC1/CC2 orientation:

For more information regarding how the orientation effects CC1/2 and cable detection, I recommend reading on section 9.3.2 (pg. 37) of the datasheet: https://www.ti.com/lit/ds/symlink/tps65982.pdf?ts=1662671210295&ref_url=https%253A%252F%252Fwww.ti.com%252Fproduct%252FTPS65982

Thanks and Regards,

Raymond Lin

0 DanS over 2 years ago in reply to Raymond Lin

Intellectual 400 points

Hi Raymond,

Thanks for your reply.

For the UI menu in your mail, which tool are you using? TPS6598x Application Customization tool or Host Interface Tools?

Rgds,

DanS

0 Raymond Lin over 2 years ago in reply to DanS

TI__Mastermind 32436 points

Hi Dan,

I'm using the TPS6598x Application Customization Tool (version 6.1.3).

Let me know if you have any further questions!

Thanks and Regards,

Raymond Lin

0 DanS over 2 years ago in reply to Raymond Lin

Intellectual 400 points

Thank you, Raymond.

0 Raymond Lin over 2 years ago in reply to DanS

TI__Mastermind 32436 points

No problem, closing this thread.

If you have any further questions or concerns, please open a new thread for better tracking!

Thanks and Regards,

Raymond Lin

Power management

Power management forum

TPS65982: How to use TPS65982 to output the "cable orientation" logic to control POL in TUSB546EVM?