• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 63 subscribers
  • Views 133 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCC21520: UCC21520 and UCC5310 power supply Question in half bridge

user5956241
Intellectual 565 points
Part Number: UCC21520

Dear TIer,

I have question about single / two channel ios-gate driver.

Why single channel iso-gate driver no use bootstrap circuit in main popular half bridge design?

It looks like a PWM IC with two auxiliary lines is used, whereas the 2-channel iso-gate driver uses a bootstrap circuit.

 

1-channel

2-channel

Power deliver iso side

Tow aux wire

Bootstrap

Chip unit

2

1
  • 0
    TI__Expert 3225 points

    Hi,

    Single channel drivers can also be used in a half bridge design. So yes, we can still use a bootstrap supply. Typically single channel driver are used to either drive high or low side separately, but dual channel drivers are almost always used in a half bridge design. This is why we mention bootstrap circuitry in dual channel drivers, but it can also be applied to any half bridge configuration. Single channel drivers also typically are powered by bias supplies.

    Regards,

    Akshat