BQ2961: Disable BQ296100 REG

Chen Jia

Part Number: BQ2961

Hello:

We are using BQ296100 as secondary protection in a 4S2P battery design, and we don't need the REG output. Just want to confirm, the REG pin should connect to GND with 30kohms (typical)?

I didn't find the detailed description in the spec about how to disable the REG (and REG_EN), but the numbers could be found in Characteristics section.

Thank you!

Chen

over 3 years ago

0 Matt Sunna over 3 years ago

TI__Guru* 81035 points

Hi Chen,

No, you do not need to connect a 30k resistor to this pin - this is showing the internal pull-down resistance when it is disabled. You can use the REG_EN pin to disable the output.

Best regards,

Matt

0 Chen Jia over 2 years ago in reply to Matt Sunna

Intellectual 850 points

Hello Matt:

Thanks for your reply. Could you be more specific, that how to disable the output by the REG_EN pin?

Thanks!

0 Luis H. S. over 2 years ago in reply to Chen Jia

TI__Mastermind 42070 points

Hello Chen,

Unfortunately it seems that none of the released BQ296x devices have the REG_EN pin. So there would be no way to disable the REG output with the currently released devices.

If REG is unused, you would still have to place a capacitor here for stability. This e2e thread may be useful: https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/971041/bq2962-bq2962-could-we-let-reg-pin-floating-when-no-use-the-rtc-ldo-feature

Best Regards,

Luis Hernandez Salomon

Power management

Power management forum

BQ2961: Disable BQ296100 REG