Hi team,
Our pcb uses TPS65994 and want to select the I_LIM5V configure to setting parameters 0/1/2/3/4.
However, we could not find any configuration parameters on the Application Customization tool.
Where to set the parameter about I_LIM5V?
Best Regards,
Yuka
Hi Yuka,
Our pcb uses TPS65994 and want to select the I_LIM5V configure to setting parameters 0/1/2/3/4.
The specific ILim5V setting parameters 0/1/2/3/4 are set within the firmware, not the App customization tool
Within the App customization tool, you can set the current limit for the 5V path through a combination of 3 settings.
Within Global System Configuration, you can set the (1) ILIM Over Shoot.
Within Transmit Source Capabilities, you can set (2) Max Current and (3) Peak Current(a percentage of max current).
A combination of the three (Max*peak + Overshoot) will determine an ocp value, and one of the I_LIM5V settings will be chosen by the firmware in runtime when based off the calculated ocp.
Thanks and Regards,
Chris
