• State Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 62 subscribers
  • Views 144 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQSTUDIO: Cannot set "configuring auto cycle"

Shunsuke Yamamoto
Expert 4511 points
Part Number: BQSTUDIO
Other Parts Discussed in Thread: BQ27421-G1

Hi team,

My customer cannot set "Configuring auto cycle" on BQstudio becuase the configuration doesn't appear on GUI. I found this configuration from this video below.

https://training.ti.com/introduction-bqstudio-and-ti-tool-chain-gauge-evaluation

Do you know any ways to solve this problem?

Best regards,

Shunsuke Yamamoto

  • 0
    TI__Guru 57747 points

    Hello Shunsuke-san,

    The configuration settings for Autocyle can be accessed using the menu Window->Preferences. Then navigate to Registers and expand the tree below it to access the Autocycle configuration setttings.

    Note:

    The Autocycle menu is only enabled when the "Registers" tab is clicked/has focus.

    Autocycle is only available for SMBus gauges.

  • 0 in reply to Shirish
    TI__Expert 4511 points

    Hi Shirish-san,

    Thank you for replying my message.

    My customer has been evaluating BQ27421-G1 If my understanding is correct, my customer cannot use Autocycle, right?

    Are there any similar functions of Autocycle?

    Best regards,

    Shunsuke Yamamoto

  • +1 in reply to Shunsuke Yamamoto
    TI__Guru 57747 points

    Hello Shunsuke-san,

    For BQ27421-G1 there is a "Learning cycle" button on the toolbar. The "automated mode" in this tab is similar to Autocycle.