Hi,
I occur a I2C slave address issue of TUSB1064, as table 9, DPEQ/A1 = 0, SSEQ0/A0 = R, I2C slave address should be 0x45, right?
Or anything I missed? I need using 0x44 to read/write TUSB1064 now. thanks!
Jeff
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Jeff
Please refer to Table 1, 'R' means 20k pulled to GND. Do you have ADDR0 pulled to ground through a 20k resistor?
Thanks
David