Other Parts Discussed in Thread: GPCCHEM
Hi,
I'm currently in the process of completing the learning cycle. So far the update status is 05 so I was able to update Qmax. After discharging the batteries from full and waiting 5 hours for relaxation, the update status does not go to 06. The [VOK] was cleared and the [REST] flag was set. I recharged the batteries and attempted a second discharge but noticed that the Ra table is not updating during discharge so it would seem that no resistance measurements are taking place at all. I've tried a C/5 rate and a C/7 rate so far. I'm using 4 Kokam LiPo batteries (3300 mAh/cell, Chem ID: 2049) in a 2S2P configuration, a requirement for my application. I attached the log from my first attempt at the learning cycle which includes the full discharge for resistance updates. Can someone advise on what may be going wrong?
Thanks,
Perry