Dear expert,
Customer want to use 100Hz (50% duty cycle ) PWM signal to control EN pin. Is it OK?
C(dVdT) = 0.8 nF
tON(dly)+tOFF(dly) =220+2=222 uS which is far below 100Hz (10ms). It should be OK, right?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Dear expert,
Customer want to use 100Hz (50% duty cycle ) PWM signal to control EN pin. Is it OK?
C(dVdT) = 0.8 nF
tON(dly)+tOFF(dly) =220+2=222 uS which is far below 100Hz (10ms). It should be OK, right?