• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 63 subscribers
  • Views 72 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPSM63606: Remote Sense on Feedback

Jason Haedt
Expert 3220 points
Part Number: TPSM63606

Hello,

In reading through the feedback on the TPSM63606, it states you can connect to VOUT at the desired point of regulation.  I was planning on routing the feedback resistors and cap near the device, but then was going to route a differential trace on VOUT/GND closer to the load.  Do you see any concerns with this approach?

I will have some local caps to generate a small plane near the device but my main load is a couple of inches away and wanted to provide better regulation at this point.  This part doesn't feature a true remote sense so I wanted to ask.     

  • 0
    TI__Mastermind 49297 points

    Hi Jason,

    You can run a trace from the upper feedback resistor to sense VOUT at the point of load. However, the GND reference is AGND, which is effectively at the DAP of the module. Typically the GND plane drop is minimal and it's more important to sense VOUT.

    Regards,

    Tim