TPSM82913: inverting Buck boost usage

Genius 4190 points

Part Number: TPSM82913
Other Parts Discussed in Thread: TPS62913

Hi,

I suppose TPSM82913 can also use as IBB. Is there any additional concerns if we try to use TPSM82913 for IBB?

Regards,

over 1 year ago

+1 Steve Schnier over 1 year ago

TI__Expert 4600 points

Hello,

While I haven't built an EVM with the TPSM82913 in an IBB configuration, you should be able to follow the same design procedure as the TPS62913IBB EVM to do that. https://www.ti.com/lit/pdf/slvuc22

0 Go over 1 year ago in reply to Steve Schnier

Genius 4190 points

Hi, Steve

Thank you for your advice.

As your advice that gave me on another thread(https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1204611/tps62913-ibb-evm-question-about-the-evm-user-guide/4547699#4547699),
we shouldn't place CIO for IBB with TPS62913.

According to the Functional Block Diagram on TPSM82913 D/S, we can find the capacitor placed between VIN and GND as follows.

I think this cap may become CIO if we use TPSM82913 as IBB, so does it mean that IBB configuration of TPSM82913 is not recommended?

Regards,

0 Steve Schnier over 1 year ago in reply to Go

TI__Expert 4600 points

Hello,

You can still use the TPSM82913 in an inverting buck boost configuration, but you will have to use the diode as recommended when CIO is present.

Power management

Power management forum

TPSM82913: inverting Buck boost usage