• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 64 subscribers
  • Views 216 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ77207: open-wire detection

Keith Keller
Expert 6660 points
Part Number: BQ77207

Hello,
We are looking to get some more info on how open wire detect works.
Particularly cell 1.  If cell one was held at 0.5V for > 4 seconds due to low SOC and/or high load current, would the OW trip?  
Is the timer for open-wire the same as the OVP/UVP?  Why is cell1 different from the other cells?
Regarding the hysteresis, the OW will recover immediately if it goes above 600mV?

Thank you, Keith

  • 0
    TI__Mastermind 38330 points

    Hello Keith,

    I spoke with our systems engineer about the timer, he mentioned that once it detects OW it should be very quick, in the us range 4 seconds as stated in the datasheet. The OW would likely trip if the cell voltage were to become that low. Yes, OW will recover immediately. 

    Cell 1 OW is different because the device cannot go too much below Vss, so the voltage needed is a bit higher. 

    Tomorrow I will try to test the cell 1 at below 0.5-V condition to see how it behaves.

    Best Regards,

    Luis Hernandez Salomon

  • 0 in reply to Luis H. S.
    TI__Mastermind 38330 points

    Continuing in e-mail. Closing thread.

    Best Regards,

    Luis Hernandez Salomon