This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

# TPS62745: Loop-Powered Application

Part Number: TPS62745

Hi Experts,

Our customer needs to know, whether the TPS62745DSSRIC is suitable for loop-powered devices (4-20mA). Expected output is 3.3V@10mA.

When they are powering at 3.6mA, The board is not powered ON. But  the IC is working fine at 5.6mA current.

The Regulator IC(TPS62745DSSR) is miss behaving in each board. The input voltage is 3.6mA loop current. Whether the silicon have some manufacturing tolerance.

Best regards,
Gerald

• Hi Gerald,

What do you mean the input voltage is 3.6mA? Do you mean the input current is limited to 3.6mA? If so, the device may not be able to power up since it need more current for driver and loading though the quiescent current is very low for this part. And what's the input voltage?

The input voltage is 3.6mA loop current.

You can also directly send me the schematic if possible.

• Hi Athos,

Thank you for your response. The input is constant current source. The input voltage is limited to 8.7V at 3.6mA.
Due to the current source input, the voltage will be very based on the load current.
The system is working in loop powered input (4 - 20mA)

Please check and let me know if you have any queries.

Thank you and best regards,
Gerald

• Hi Gerald,

If the input is 8.7V at 3.6mA, it is definitely not able to supply 3.3V at 10mA output.

You can see the input power 8.7*3.6 is less than the output power 3.3*10 without taking the efficiency into consideration.

Assume the efficiency is 0.85, the input power must be higher than 3.3*10/0.85=38mW to support the output.