Hi,
Need design review of the attached design:
Input voltage: 6 - 35V
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
TI E2E support forums Any help on the above is appreciated. Planning to send the device by tomorrow.
Hi Shyam,
Looks fine. If you need input reverse polarity protection, please do not short RTN and GND pin.
Regards
Kunal Goel
Hi Shyam,
EP should be connected to RTN and not ground.
Regards
Kunal Goel