This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

UCD90160A: Noisy input rails - debug advice

Part Number: UCD90160A

My UCD90160A design seems to be measuring all rails like they are very choppy, going up and down like 5-10%.

I don’t have a ferrite filter for the analog rail, and the common digital rail has some 11mV switching noise on it.

Is there any way to tone the noise seen by the ADC down? Like sample rate change, or averaging?

  • Hi

    a decoupling cap on MONx pin is required. a 4.99ohm resistor between V33D and V33A is also required to reduce the ripple on V33A.

    The ADC sample is not controllable.

    Regards

    Yihe