Hi
I need to get 0.95V in the Vout, I try to understand the calculation
according to table 7-12:
Resistor divider code = 2
Code = (0.95-0.9)/0.01 = 5
So in this case, I need 2 resistors from Vsel Pull up to BP1V5 and Pull down to AGND
Vsel to AGND (Rbot) = 12.1K and Pull up to BP1V5 = 30.1K
Am I right?
One more question - I seen in the Evaluation that AGND not connected to PGND. But in the datasheet recommendation is to connect the AGND direct to the E pad. that mean the connection is inside the chip?
Thanks
