LM36010: peak eff @ 100mA

Hi Given,

Sure, and do I need to test the efficiency curve or just make sure the efficiency could meet their requirement?

Besides, could you also provide us more details about the customer and their applications?

Thanks!

Ives Li

Hi Ives,

Thanks for your reply. 

customer want to check if our peak eff can meet their requirement. If we know where is peak, we can just test that point to see if it's OK and we can tell customer which Vin is OK. I think 2.5V may be too low to meet the requirement. 

I'll inform you on the customer offline. Thanks. 

BRs

Given

Hi Given,

I tested the efficiency curve on 100mA/25C condition, you can see the result below:

It seems the efficiency is always higher than 85% from 2.6V to 3.3V.

Thanks!

Hi Ives, 

Thanks for your reply. how about 80% @ 85C?  based on curve in datasheet, There is 1~2% gap between 85C and 25C, then it should be met, right? Thanks. 

BRs

Given 

Hi Ives, 

Thanks for your reply. 

It's OK and healthy is more important. Take care. 

BRs

Given